oil level BMW Z4 COUPE 2006 E86 Service and warranty information

Page 7 of 54

BMW recommends that you check engine oil
level whenever fuel is added to your vehicle.
– Inspection I: Major vehicle maintenance as specified in the following pages under Inspec-
tion I.
– Inspection II: Additional major vehicle mainte- nance as specified in the following pages under
Inspection II.
The following maintenance elements must be
performed at the mileage/time stated (time inter-
vals begin from the vehicle’s production date):
– Brake Fluid Service: Change brake fluid every two years.
– Oxygen Sensor Service: The oxygen sensor deteriorates strictly on a mileage basis and
must therefore be replaced every 120,000
miles to maximize vehicle fuel economy and
minimize exhaust pollution. The replacement of
the oxygen sensor is required under the terms
of the applicable BMW emission system war-
ranties.
– Spark Plug Service: Replace spark plugs every 100,000 miles.
– Automatic Transmission Service: Change ATF every 100,000 miles. The engine coolant has a lifetime rating and does
not need to be changed.
For your convenience, you may also wish to have
your BMW center perform any necessary opera-
tions to fulfill any state inspection requirements
in your area concurrent with the maintenance
elements specified above during other repairs.
Make sure that confirmation of maintenance
work is always entered in this Service and War-
ranty Information Statement. You may need this
for any warranty claims that become necessary,
and later on as evidence that your car has been
given the correct and regular maintenance that
justifies its resale or trade-in value.
BMW has applied the most modern technologi-
cal advances not only to the design and produc-
tion of your vehicle, but also to computing of the
optimum maintenance interval for your type of
operations and driving style. Your BMW center
has made a substantial investment in unique
BMW special service tools to enable his BMW
factory trained service technicians to perform
quality repairs on your BMW in minimal time.
He/she looks forward to serving your every ser-
vice need and to help maximize your satisfaction
with your BMW, its longevity, and resale value.
3

Page 10 of 54

Inspection I
Only those items of inspection work which apply to your vehicle will be performed. This list is subject to
amendment.
Undercarriage
Z4 Roadster 3.0i, 3.0si
Coupe 3.0si
Change oil and oil filter while engine is at normal operating temperature. We
recommend BMW 5W-30 High Performance Synthetic Oil, p/n 07 51 0 017 866. •
Check transmission for leaks. •
Check rear axle for leaks. •
Half-shafts: Check for leaks at flexible boots. •
Visually check fuel tank, lines and connections for leaks. •
Check condition, position, and mounting of exhaust system. Examine for leaks. •
Check steering for absence of play, condition of suspension track rods, front axle
joints, steering linkage and joint disc. •
Check overall thickness of front and rear disc brake pads using special tool. If
replacement is necessary: Examine brake disc surfaces. Clean brake pad contact
points in calipers. Grease wheel centering hubs. Check thickness of parking brake
linings only when replacing rear brake pads. Check brake system connections and
lines for leaks, damage and incorrect positioning. •
Check parking brake actuation. Adjust if necessary. •
Check all tire pressures. Correct if necessary. Check condition of tires (outer
surface [left/right]), tread wear and pattern; in case of uneven tread wear, readjust
wheel alignment if requested (invoice separately). •
Inspect entire body according to terms of rust performation limited warranty. (Must
be performed at least every two years). •
Engine Compartment
Read out diagnostic system.

Check engine cooling system/heater hose connections for leaks. Check coolant
level and antifreeze protection level. Add coolant if required. •
Check windshield washer fluid level and antifreeze protection. Fill up and/or
correct if required. •
Check air conditioner for operation. •
Replace microfilter (Note: reduce replacement interval in dusty operating
conditions). •
Reset service interval indicator. •
Check brake fluid level. Add fluid if needed •
6